angel eye transformers

[felstmiester]

Just got the angel eyes through the post today, second hand from a forum member, plugged them all in to check they worked before dismantling the lights and one side worked but the other only one halo worked, after a lot of swapping transformers from one side to the other it turns out that one transformer is F*CKED!!! :mad:

Can they be brought seperate?? :confused:

[benny boy]

Teddy sells spares mate contact him

[felstmiester]

Teddy sells spares mate contact him
Ok, i'll give him a bell tomorrow. Cheers.

[Hairyarsedhighlander]

peppernick has just replied to a thread you have subscribed to entitled
- CCFL Problems - in the EvoTechnik Main Forum forum of EvoTechnik.

This thread is located at:
http://forum.evotechnik.net/showthread.php?t=13463&goto=newpost

Here is the message that has just been posted:
***************
Sounds like a contact/connection issue. Also, have you noticed any
change if you rev the engine? or take it out for a drive? Sometimes the
voltage stabilises with the engine revving more than at tick over.

I had similar issues with my halos back in the days when they first
came out. Found that by hardwiring all the wires and eliminating plugs,
the contacts were much better and it cured the problem.

................................

First thing I tried was to plug Inn my kitt, I have 3 inverters and 6 eyes. The same problem. Near side worked fine but off side - one ring worked and the other was very faintly lite. Basically I connected the two wires to the battery and they all worked fine. I am awaiting some new bulb holders to modify these and will try and see if this fixes my connectivity issue and not have to modify my current wires. When I installed them at first they worked fine for a month and then they were intermittant. I should hopefully have the bulb holders tomorrow and fitted b4 the weekend is over and will let you know how it went. Try the battery test first before ordering new inverters.

Hairyarsedhighlander